Community › Forum › B.One Community Forum › Introduction to Lora Wan and connection of a Gateway
Introduction to Lora Wan and connection of a Gateway
Posted by System_Doc on 27. November 2024 at 10:14Hello everyone, I’m new to this topic and have shopped a lot at Zenner. I would like to know how to integrate a Gateway Smart into your own B One gallery so that you can see your sensors there. Perhaps there is someone who can give me a quick hand. Thanks.
System_Doc replied 6 days, 9 hours ago 1 Member · 0 Replies- 0 Replies
Hello @System_Doc , there have been similar questions/discussions in the forums before, but I’ll try to summarize it, although one must also differentiate a little:
Activation ZENNER Gateway SMART
To activate your Gateway Smart, I recommend at first the following blog post: https://community.zenner-connect.com/en/blog/iot-gatewayplus-smart-get-started-in-less-than-5-minutes/. Basically, you only have to plug the GW into the socket once and connect it to the local WLAN, as described there. After that, it should be online and ready to receive data. It is NOT necessary to add the gateway in your own tenant beforehand. In addition, A gateway ordered in the shop is currently not visible in the customer’s own client, as described in the blog post about the GW Smart under “Advantages & Limitations”: https://community.zenner-connect.com/en/blog/zenner-iot-gatewayplus-smart-compact-indoor-gateway-with-lorawan-network-for-the-socket/. The same applies to the B.One Gallery.
B.One Gallery
If you would like to have your sensor data visualized in the B.One Gallery, you can simply add it to your B.One Gallery account, as described in the following blog post: https://community.zenner-connect.com/en/blog/b-one-gallery-howto-add-sensors/. However, you do not need to do anything else in the ZENNER Datahub, as can also be read in the post.
Additionally, I can also recommend the following blog posts and similar forum discussions:
- https://community.zenner-connect.com/en/blog/quick-guide-b-one-gallery/
- https://community.zenner-connect.com/en/blog/visualization-tool-b-one-gallery-an-introduction/
- https://community.zenner-connect.com/en/forums/discussion/how-do-i-get-access-to-the-b-one-gallery/
- https://community.zenner-connect.com/en/blog/howto-install-lorawan-sensors-avoid-missing-data/
Hope this helps 🙂
Best regards
ZENNER IoT GatewayPLUS SMART – Get started in under 5 Minutes
Log in to reply.