Community Forum ZENNER Datahub Forum Event time vs Device time in ZENNER Datahub

  • Event time vs Device time in ZENNER Datahub

    Posted by Rajib on 10. May 2024 at 12:28

    Hello team,

    I would like to know the difference between the Event time and the Device time in the parsed reading section of the LoRaWAN Devices. Are they both part of the device payload?

    Rajib replied 6 months, 3 weeks ago 3 Members · 3 Replies
  • 3 Replies
  • Michi

    Member
    13. May 2024 at 17:49

    Hi Rajib,

    The naming of the two parameters can actually be a bit confusing. Here is the difference:

    • Event Time = Date & time of sending/transmission of the respective measured value (reading) or data packet
    • Device Time = Date & time of recording the respective measured value (reading), also corresponds to the value “Timestamp” in the “Packages” tab

    And yes, both are part of the device payload.

    I hope this answers both of your questions.

    Best regards!

  • Community Admin

    Administrator
    13. May 2024 at 18:11

    Thanks @Rajib for the good question and @schwooz for the great answer!

    Will be added to the list of ideas for future optimizations in the Datahub👍🛠

    Best regards

  • Rajib

    Member
    13. May 2024 at 19:20

    Thank you for your detailed explanation. It’s clear now. @schwooz

    @Community-Admin Thank you for your appreciation and considering updating the DATAHUBS to make it more understandable.

Log in to reply.